Update on Motive Power

Almost all of the pieces have arrived.

The kit for the L1 Pennsy 2-8-2 is going well. At first I thought I would not be able to use the tender casting, but when I took a good look at the Bachmann tender I found that it's shell pulls straight off the top and has what looks suspiciously like a decoder in it. At any rate, with a bit of judicious trimming of both tender floor and the casting, including removing the coal bunker floor and replacing it with a piece of styrene cut to fit just a bit higher, the Pennsy casting will work fine on the Bachmann floor.

I had to modify all three of the tender drawbars by gluing in a piece of styrene and drilling a hole to connect to the locomotives. On the Atlas locos I drilled a hole in each of the trailing trucks and bent a thick piece of brass rod as a connector. On the Kato I bent a piece of the same brass rod to fit in the existing trailing truck hole. All three tenders will now connect to their respective locomotives, but I might have to rethink the Kato as it is a bit too close for operations on tighter curves. I'm planning on running a minimum of 15" on the standard gauge, but I'm not sure if the Kato will make a curve that tight with the current coupling distance.

I also modified the slope-back tender for the 0-6-0 by clipping the part of the old tender's drawbar that connected to the locomotive and trimming it to fit inside the new tender's drawbar opening. Now I have a good tight fit and a better contact system than before so this locomotive, already a good performer, is now a great performer. It is very difficult to stall this locomotive now since it picks up from both tender trucks as well as from four of the six locomotive wheels. It still won't pull a full length freight train, but the prototype never did either. It does just fine with a cut of four to six cars, I haven't tried it on anything more than that but this will likely be it's standard train length anyway.

The worms have been removed from the Atlas locos along with their enclosures, they will be sent to the Motorman to be installed on the gearmotors that are being built for them. At present the only one of the three locos that run is the Kato, and it is a real jewel. I have to finish detailing the L1 shell and it will be ready for paint and decals. It is a running locomotive that needs cosmetic work, the Atlas locos are good cosmetically but don't run. All that will change when the new motors get here, but there is no rush since I don't have an operational pike for the moment.

There has been one final addition to the roster, and this one is completely non-prototypical. It is a Bachmann Class J Norfolk and Western 4-8-4 with auxiliary water tender. I have to install couplers to close the gap between the tender and aux tender, and I would also like to close the gap a bit between the loco and tender, but it is as beautiful as it's prototype counterpart. It is road number 611, which is also the only surviving prototype of it's class. In my opinion, the N&W J class locomotives were the most beautiful steam locomotives ever produced.

So what is a N&W J class doing on a PRR themed pike? The story I'm making up is that it's leased with an option as the "PRR" contemplates a switch to diesel. In the real world, it's my railroad and I'll run what I like.

Nowadays of course the N&W and the PRR are combined into the Norfolk Southern on the part of the Pennsy system that I'm modeling.